Version 2.0
143
Automatic Identification System
Operator’s Manual
Configuring the AIS Static Setup
The AIS Static Setup contains both the ship’s static data and AIS transponder
configuration. This setup must be done after installation or at any time changes
are made to the ship’s AIS transponder unit.
It is important to note that critical AIS static setup items (such as MMSI, IMO,
Ship name & Call Sign) are password protected. Setup items that require
administrator password are indicated in the
Display Field Descriptions
below.
If an invalid or missing password is used, an ‘AIS Alarm’ is displayed and the
entry will be rejected. Press the ‘Cancel alarm’ softkey to continue.
Follow the procedure below to enter the required AIS static information for SAAB
transponder:
1.
Press
CFG
key.
2.
Highlight the
AIS Static
under the ‘Item’ column.
3.
Press the
E
key to start editing the AIS Static setup.
4.
The “AIS Connected (Port 5): - No” will be highlighted, press the
Change
softkey to change it to “Yes”.
5.
Move the highlight to other required setup items and enter the numeric
values or press the Change softkey to toggle the value.
6.
Press
E
key when done editing the AIS Static menu.
More AIS Static configuration parameters are available by scrolling down
using the down arrow cursor key as shown below.
Summary of Contents for MX420
