Version 2.0
193
Demonstration Mode
Operator’s Manual
Appendix F - Demonstration Mode
This enables the CDU to function as though you are under way, even
though you are completely stationary. The default setting is
No
. When
set to
Yes
, all three Traffic Lights will be illuminated, and a
D
symbol is
displayed in the upper left corner of every display. Generally speaking,
this feature is used by MX Marine and your dealer for show room or
trade show demonstrations. However, you can use it as a training tool
until you become familiar with the CDU. You can also use it to output
NMEA 0183 records on the data ports to test and demonstrate other
devices such as autopilots, chart plotters, and radars.
In the
CFG
Operation
screen, activate the
Demonstration Mode
by
selecting
Yes
.
Follow:
Active Route:
causes the CDU to use the route loaded in RTE1
screen.
Rhumb Line:
causes the CDU to follow the bearing you input in
this screen under
Demonstration COG
.
Demonstration SOG:
causes the CDU to simulate a speed of up to 99
knots. Slower speeds of 5 to 25 knots provide the best demonstra-
tion results.
Demonstration COG:
causes the CDU to simulate a course over ground
of up to 359.9 degrees when Follow is set to
Rhumb Line
.
To setup your course, load the desired waypoints into
RTE1
. Notice
that the CDU loads your point of departure as N 00, W 000.
Summary of Contents for MX420
