194
Version 2.0
Operator’s Manual
Demonstration Mode
Before you adjust your position, set your
WPT Pass Criterion
to
Dis-
tance
in the
CFG1 Navigation
screen. To adjust your position, pick a
point near your first waypoint. A distance of 1 or 2 miles from the first
waypoint is good to start with. Go to the
POS1
screen and press
E
.
Next, press the
NAV
function key, then the
E
key. Press the
Reset XTE
softkey. Press the
E
key. This resets your cross-track error and up-
dates the active route in
RTE1
with the adjusted position.
Now just use the CDU as you normally would. You can output NMEA
0183 data records to other devices.
Be careful, however, other instru-
ments will interpret the data as completely valid.
So, don’t run the
Demonstration Mode
while you are underway and connected to de-
vices that are being used in real time, like your autopilot.
Summary of Contents for MX420
