Version 2.0
27
Navigate O
perator’s Manual
Below this information, you will find your Set and Drift data, which is
calculated using GPS and your compass and speed sensor inputs.
Reset XTE and Skip Waypoint
, described at the end of
NAV2
, is also
available in
NAV4
.
The window on the right displays depth information coming from the
depth sounder unit using the NMEA 0183 record of DPT, DBS, DBT, or
DBK. These are setup in the
CFG1
Depth
screen, refer to the
Con-
figuration
section of the manual and the
Installation & Service Manual
for full details on depth data.
Below the depth data you will find the next route leg vector, the
Range
to the waypoint and
Time To Go
data, explained in the
NAV3
section.
Note: The NAV screens are not active until antenna is detected.
Summary of Contents for MX420
