Version 2.0
35
Route
Operator’s Manual
Insert By Number
The following example assumes
RTE1
is empty. Follow the directions
in the
Erasing an Existing Route
section to start with an empty route
if you have waypoints in the
RTE1
screen.
1. Select the
RTE
key until the
RTE1
screen is displayed.
2. Press the
E
key to enter the edit mode.
3. Select
Insert
from the display. Skip to the next step if RTE1 is empty.
4. Select
Insert by Number
from the display.
5. Use the keypad to type in the number you want or the beginning
number of a range you would like to select from, or use the cursor
key to scroll through the previously stored waypoints in numerical
order.
6. When you have found the waypoint you want, press the
Insert
this WPT
softkey.
7. You can then choose to select another waypoint using the same
method, select
Escape
to go back one level and use another method
to enter waypoints, or select
Done
to go back to the main menu.
8. Don’t forget to press the
E
key to end your editing.
Summary of Contents for MX420
