40
Version 2.0
Operator’s Manual
Route
Use the up (
Ï
) softkey to unpass or the down (
Ð
) softkey to pass
waypoints in the route until the waypoint marked by the cursor is
displayed with white characters on a black background (Daylight dis-
play, see
CFG1
Lighting
).
Press the
E
key to end editing.
If for some reason you can’t select the waypoint you want (the screen
keeps passing waypoints you unpassed), you are probably too close
to one of the waypoints. You will need to either change your
Waypoint
Pass Criteria
, change your
Waypoint Pass Distance
(see
CFG1
Navi-
gation
), or remove the waypoint from the route.
In
serting Waypoints or Routes into an Existing Route
1. Select the
RTE
key until the
RTE1
screen is displayed.
2. Scroll through the route with the cursor key until the cursor arrow
is at the bottom of the waypoint you want to insert the new
waypoint after.
3. Then press the
E
key.
4. Use one or more of the insert methods described in the
Creating a
Multi-Waypoint Active Route
section above.
This example shows Waypoint 7 inserted into the route using the
Insert by Number
method:
Summary of Contents for MX420
