Version 2.0
43
Route
Operator’s Manual
ETA Setup
If you choose to use this function, it is probably better to operate the
unit in UTC time mode if you are going to cross one or more time zones.
Note that the time entered uses the offset to UTC applied in the
CFG1
Time
display.
The software calculates Estimated Time of Arrival based on how you
configure the unit. ETA settings are controlled from the
RTE1
screen.
To change the ETA settings:
1. Select the
RTE
key until the
RTE1
screen is displayed.
2. Press the
E
key.
3. Select the
ETA/SOG Calc.
softkey.
4. Use the
Change
softkey to select which value you want the
CDU to calculate, either
ETA
based on speed, or speed (
SOG
) based
on desired time and date of arrival.
Summary of Contents for MX420
