48
Version 2.0
Operator’s Manual
Waypoint
For example, if you are looking for the LA HARBOR ENTRANCE
and you enter HAR, the screen will display all waypoints with
these three characters in this exact order.
Creating and Editing Waypoints
When editing a waypoint, you are always prompted to select the ap-
propriate datum. You might occasionally see a prompt warning you
that the waypoint is used either in a stored route or the active route.
You ultimately have the final decision whether to continue editing
the waypoint, or exiting this waypoint by pressing the
E
key again to
exit the edit mode.
Creating and editing waypoints is easy.
1. Select the
WPT
key until the
WPT1
screen is displayed.
2. Press the
E
key.
3. Press the
Make New WPT
softkey or align the cursor with the
waypoint you want to modify and press the
Edit this WPT
softkey.
Summary of Contents for MX420
