Version 2.0
59
Waypoint
Operator’s Manual
CFG1
NMEA Out
screens for the identifier given below. The CDU
outputs these sentences in the following format:
Rnn
- Routes:
Waypoint identifiers, listed in order with starting waypoint first, for
route number “nn”. The active route in the CDU is always route zero,
but in the Rnn sentence the route number can be transmitted as either
route 00 or 01.
Rnn
is NMEA version 1.5. Use of
GPRTE
is recommended to comply
with NMEA version 2.1.
field#: 1 2 3 4 1 1 1
4 5 6
$GPRnn,cccc,cccc,cccc,.....,cccc,cccc*hh<CR><LF>
explanation / actual use:
1:
nn = active route number, 00 or 01
can be set to 00 or 01 (default 00).
2 - 15:
14 field sequence of route waypoint IDs.
16:
Checksum can be set on or off (default on).
RTE
- Active Route:
Waypoint identifiers, listed in order with starting waypoint first, for
the identified route. Two modes of transmission are provided: “c” indi-
cates that the complete list of waypoints in the route are being trans-
mitted; “w” indicates a working route (active) where the first listed
waypoint is always the last waypoint that has been reached (FROM),
while the second listed waypoint is always the waypoint that you are
currently heading toward (TO). The remaining list of waypoints repre-
sents the remainder of the route.
RTE can be sent as version 2.1 and 2.0.
field#: 2 3 4 5 6 1 1 1
5 6 7
$GPRTE,x,x,a,cccc,cccc,.....,cccc,cccc*hh<CR><LF>
explanation / actual use:
2:
Total number of messages being transmitted (a single route
may require the transmission of multiple messages). A maxi-
mum of 11 waypoints are transmitted in each messages.
3:
Message number.
Summary of Contents for MX420
