Version 2.0
77
Plot
Operator’s Manual
PLOT 2 - Relative to Marker
The
PLOT2
functions are the same as the
PLOT1
. Refer to the previ-
ous section for customizing the display. One added feature to the
PLOT2
screen is the ability to place the marker at any coordinate that
you want and have the CDU automatically calculate a bearing and
distance to the marker.
If you want to relocate the marker, press
E
to enter the edit mode, then
press the
Move Marker
softkey. You can move the marker by: defining
a coordinate (see the flashing cursor over the coordinates in the upper
left window), moving the magnifying glass using the cursor keys and
pressing the
To
softkey, or by pressing the
Too
softkey, which
moves the cursor to the boat’s present position. If you choose to use
the magnifying glass method, make sure you move this icon before
you select the
Move Marker
softkey. After you press the
Move Marker
softkey, pressing on the cursor keys only allows you to move within
the coordinate fields.
PLOT3 - AIS Plotter Display
This plot screen is available only in MX420/AIS and MKD CDUs. It is
accessed by pressing the PLOT key the third time. It displays a graphic
picture of the area surrounding your vessel. In this display any AIS
equipped vessel that is within the range will be shown. A maximum of
20 AIS targets will be displayed in the plot 3 screen.
More PLOT 3 screen details are available in Appendix A.
Summary of Contents for MX420
