Version 2.0
81
Man Over Board
Operator’s Manual
To cancel an MOB condition, make sure you are in the MOB Plot
screen. Press the
E
key, then select the
Cancel MOB
softkey. Press
E
again to exit the edit mode.
Remote MOB
The MX420/8 is capable of performing the MOB function from a re-
mote contact closure input via Cable B “MOB/Event” wire shared with
the Mark input. If the contact closure is made for less than 2 seconds,
the input is registered as a Mark Position. If the contact closure is
made for more than 2 seconds, the input is registered as a MOB Posi-
tion. Refer to the
Installation & Service
manual for wiring interface
instructions.
Summary of Contents for MX420
