17
NETWORK SETTINGS
7.2.3 Common Settings
From the FS-GUI Network Settings landing page, click on the
Common tab.
Note
Default is Primary Connection is Ethernet.
To change the primary connection when both Ethernet and Wi-Fi
Client connections are available:
1. Select the desired option from the drop-down menu on the
right.
2. Click Update Common Settings, then click on System Restart to
restart the gateway and activate the new settings.
Note
If using Wi-Fi Client and not Ethernet, change
Primary Connection to Wi-Fi.
Figure 28: FS-GUI Common Network Settings
Note
The fields below the update button show the settings
as they were set in the IP Settings or Wi-Fi Client pages.
They are not editable on the Common page.
Figure 27: FS-GUI Wi-Fi Client Network Settings
Wi-Fi Client Fields
Definition
Connection Status
Status of connection
MAC Address,
BSSID, Channel
Wi-Fi Client MAC Address, BSSID, and
Channel
Tx/Rx Msgs
Number of transmitted and received
messages
Tx/Rx Msgs
Dropped
Number of unanswered Tx or Rx messages
Pairwise Cipher
Type of encryption used for unicast traffic
Group Cipher
Identifies the type of encryption used for
multicast / broadcast traffic
Key Mgmt
Encryption type
Link
Connection speed
Signal Level
Signal level in dBm (see
)
Summary of Contents for Modbus/BACnet Gateway
Page 37: ...Memo...
Page 38: ...Memo...
