4
5
5. Position and Mounting
a) Start by assembling the naviflash monitor and swivel arm and hol-
ding it in different positions in your car and choose the most convenient
position for the navigation system.
The navigation system is operated via touchsreen. For this reason it
should be placed that way a driver can easy reach it with his hand.
Important:
When placing the monitor make sure it doesn’t obstruct
your sight while driving. Please also make sure to install
naviflash well outside all passenger impact areas in the pas-
senger compartment and also outside the expansion areas
of any airbags in your car. Install it in place where you can
easily take it off from the swivel arm.
The navigation system is equipped with an integrated GPS
antenna. However, please note that heat insulation glass
with vapor deposited metal layer blocks signals from out-
side to inside and vice versa. Please check if naviflash recei-
ves GPS signals inside your car before mounting / attaching
the base plate. Activate naviflash inside your car. If after 5
minutes the name of the street and city of your current po-
sition are not displayed on the screen saver this means the
GPS signal received inside the car is not strong enough.
b) Please use the enclosed cleaning cloth to degrease the surface whe-
re you want to attach the base plate. Through the use of the swivel
arm, the system can be easily removed from the vehicle, for use in a
second vehicle, for example.
c) Place the suction pad of the swivel arm on the car windscreen. Loo-
sen the hinge fitting B in order to place the pad on the dashboard.
Next, press down the catch A so that the swivel arm is fixed onto the
windscreen. Next, close the hinge fitting B. Now move the foot C to the
left or right in order to set the optimum viewing angle.
On/Off
key
Audio-Output
Memory Slot
Reset key
4. Description of Basic Unit
Mounting of navigation system
Headphone jack
Power supply
USB-Connector
A
B
C
