60
NAVIGATION
3.4.8 Changing the Road Types Used in Route Planning
To recalculate the active route with different road type preferences, do as follows. These changes
can also be made in Settings as described later in this manual
1.
If you are on the Map screen, tap
and then
.
2.
Tap any of the listed road types to modify the route. If needed, scroll the list for all road
types. You have the following options (their order depends on the selected vehicle type):
You might need to avoid motorways when you are driving a slow
car or you are towing another vehicle.
Charge roads are pay roads where you can purchase a pass or
vignette to use the road for a longer period of time. They can be
enabled or disabled separately from toll roads.
The software includes toll roads (pay roads where there is a per-
use charge) in the routes by default. If you disable toll roads, your
software plans the best toll-free route.
The software includes ferries in a planned route by default.
However, a map does not necessarily contain information about
the accessibility of temporary ferries. You might also need to pay a
fare on ferries.
The software excludes unpaved roads by default: unpaved roads
can be in a bad condition and usually you cannot reach the speed
limit on them.
The software will calculate the rout based on the lowest CO2 level
from the figure entered in the vehicle settings.
3.
Tap
to confirm the changes. The software recalculates the route. The
orange line now shows the new recommended route.
Summary of Contents for GPS unit
Page 9: ...9 NAVIGATION NAVIGATION...
Page 88: ...88 HARDWARE Hardware...
