USER MANUAL
NAVWATCH-S10
11 |
P a g e
then be added to any previous lap result as shown in the above smaller timer
digit readout. The larger timer read-out will continue to roll.
3.
Each subsequent press of the LIGHT button will advance the lap number on the
screen.
Note: This device can store up to 10 entries. The stopwatch should be stopped and reset
if further records are needed.
4.
Press the LIGHT button once timing has finished.
5.
To scroll through each timer record, press the FUNCTION button repeatedly. To
reset the unit back to 0 (zero) and to clear the memory data press the REC button
again.
6.
To return back to the main time screen press the MODE button.
SETTING THE ALARM
1.
From the time screen, press the FUNCTION button.
2.
Use the LIGHT (scroll up) or the REC (scroll down)
buttons until you see the letters ALM (Alarm)
appear on the screen.
3.
Press the FUNCTION button to enter this feature. The
number 1 (one) will then appear next to ALM. Toggle
between alarm settings 1, 2 and 3 using the
LIGHT (scroll up) or the REC (scroll down) buttons to adjust the values.
4.
Press the FUNCTION button to enter an individual alarm
time setting screen.
5.
Use a combination of the FUNCTION button to move you through the alarm fields
and the LIGHT (scroll up) or the REC (scroll down) buttons to adjust the time
values. Finally choose whether to have this alarm turned ON or OFF.
Note: If an alarm is selected and turned on, a picture of a BELL
will appear at the top of the screen.
