Getting Started
Preparing your NAVIGON 2100/2120 for use
January 2008
NAVIGON 2100/2120 User’s Guide
9
Revision 1.0
NAVIGON, INC.
Securing the cradle
Clean and dry the mounting surface and the suction cup on the base of the cradle.
These areas must be dry and free of dirt and grease.
1. Unscrew the holding screw from the cradle.
2. Align the back of the holder into the cradle.
3. Replace the screw and tighten to secure the holder in the cradle.
4. Using the suction cup, fix the cradle provided to the mounting surface. The cradle
should be as level as possible.
5. Press the suction cup lever down.
Securing the navigation device to the cradle
The holder has two small projections on the bottom and one on the top. These projec-
tions are designed to fit into corresponding slots on the bottom and top of the
NAVIGON 2100/2120
.
1. Insert the navigation device into the holder by aligning the two bottom projections
into the slots on the bottom of the device.
2. Tilt the device backward slightly until the top projection clicks into place in the top
slot.
3. Adjust the navigation device so that it can be seen easily.