Basic Operations
Starting the NAVIGON 2100/2120
January 2008
NAVIGON 2100/2120 User’s Guide
19
Revision 1.0
NAVIGON, INC.
Initializing the GPS receiver
In the upper right-hand corner of the display, the
GPS
symbol appears. As soon as
data from at least 3 satellites is received, the symbol changes to
GPS Ready
.
Setting the volume
The volume of the spoken driving instructions can be adjusted during navigation.
With a map displayed:
1. Tap (
Volume
)
.
The volume bar opens. It contains three buttons for adjusting the volume:
(
Louder
)
, (
Softer
)
, (
Volume on/off
)
.
2. Tap (
Volume
)
again.
The volume bar closes.
Note
:
GPS initialization requires data from at least three satellites. If GPS data is
not available, the receiver will not initialize.
Note:
It can take up to 20 minutes to initialize the integrated GPS receiver for the first
time.
Note:
Each time you turn on the device, GPS receiver initialization begins. When GPS
data is available, reception starts within one minute.
If the navigation device has been switched off for more than a week, the next initializa-
tion can take up to 10 minutes.
Note:
If the GPS symbol displays
GPS Ready
after considerably less than 20 min-
utes, it is advisable to leave the receiver switched on for at least an additional 15 min-
utes to ensure reliable operation.
Caution!
If you have connected the navigation device to the power supply via the
vehicle's cigarette lighter, remove the connector before you leave the vehicle standing
for a longer period of time.
As the GPS receiver requires a constant supply of power, it could drain the vehicle´s
battery.
