User’s manual MN7 PDA
Before you begin
- 11 -
2.6 Activation
If the automatic activation by SMS fails to work or if you have re-
installed the navigation software on a different memory card, then you
must activate the full version of the navigation software (or any
additional purchased maps) manually.
1. Start the navigation software on your PDA.
2. Tap in the
T
RY
&
B
UY
window on Options > Enter Activation Code.
- OR -
In the
M
AIN
M
ENU
window tap on Options > Activate > Options >
Enter Activation Code.
3. Enter the activation code which you received by SMS.
4. Tap on Next.
A corresponding message appears if the activation process was
successful.
5. Tap
on
OK.
2.7
Connecting the GPS receiver
Note:
To navigate with
MN7 PDA
you need a GPS receiver which
supports the NMEA protocol.
This type of GPS receiver may already be integrated in your PDA.
Please refer to your PDA manual.
You may have purchased
MN7 PDA
as part of a package which
includes the required components.
Otherwise you can purchase such a receiver from a specialist dealer.
►
Connect the GPS receiver if it has to be connected to the PDA with
a cable and possibly to a power source.
►
If the GPS receiver is not integrated in the PDA, switch it on and
position it as far forward as possible under the windscreen, flat
against the dashboard.
Configuring GPS
When you start
MN7 PDA
for the first time, the
GPS
C
ONFIGURATION
window opens up. You can undertake the GPS configuration manually,
or use a wizard.
This configuration will be applied to each subsequent start of
MN7 PDA
.
If you want to use a different GPS receiver, then you will have to repeat
the configuration process.
Tap on Options > GPS Status > Settings to go to the GPS configuration
screen.
