User's manual MobileNavigator | 5
- 10 -
Installing the hardware
2.2
Installing the hardware
2.2.1
Installing the PNA in the vehicle
Attention: The mounted holder must not interfere with the
driver’s attention to traffic. In case this is not possible, use the
provided adhesion plate to mount the holder somewhere else so
that safe driving is granted.
Note: You need not execute steps 1 and 2 if you want to mount
the holder on your windscreen.
Mounting the
holder...
1.
Remove the lamination sheet from the adhesion plate.
2.
Stick the adhesion plate at a convenient place on the
dashboard. Make sure that the surface of the dashboard is
clean and dry and press the plate forcefully on its place.
Note: Do not charge the plate for the first 24 hours in order
to grant its hold.
3.
Attach the cradle of the device to the swan-neck mount.
Note: Take notice of the inscription on the swan-neck mount.
The arrow with the inscription close must show in snap-on
direction. The connection must snap on audibly.
Note: Thoroughly clean the windscreen with glass cleaner. If
temperatures are below 15° C, warm up the windscreen and
the suckers beforehand.
4.
Place the suction cup on the windscreen. Press the lever
firmly to the windscreen before switching it.
5.
Insert the device into its holder. First place the bottom of the
device correctly, then push it backwards until it snaps into the
clip.
6.
Insert the chinch jack of the power supply cable into the
respective socket at the bottom of the device.
7.
Insert the power jack into the cigarette lighter.
Summary of Contents for MobileNavigator 5
Page 1: ...User s manual MobileNavigator 5 as on June 2006...
Page 8: ......
Page 94: ......
Page 106: ......