1. Introduction
The NL-464US is a USB GPS receiver with internal antenna and a 20 channel Sirf3 GPS chipset.
The USB interface enables the connection to a notebook, UMPC, tablet- or Car PC. Due to its
extreme compact design it acts as ideal companion on every tour.
1.1. Package content*
1x Navilock NL-464US
1x USB extension cable
1x 8cm CD ROM (incl. manual)
*Make sure that the product package contains all items before operation. If any item is
missing or damaged, then please contact your dealer immediately.
Important health- and security information
If you use this product you should take precautions to avoid damages and legal consequences. Follow precisely all security- and
handling advice and keep it carefully. Pay attention to all warning notices in the manual and on the device. To avoid injury, electric
shock, fire and damages on the device, please pay attention to the following notices.
Electrical Security
This product is intended for operation with power via USB connection. Any other application can be dangerous and lead to loss of any
warranty claim for this product.
NOTE: RECYCLE OR DISPOSE THE DEVICE ACCORDING TO THE APPLICABLE
REGULATIONS.
SECURITY ADVICE REGARDING DIRECT SUNLIGHT
Make sure the device is not exposed to over humidity and extreme temperature. Don't let the device for too long in a vehicle or other
places where the temperature can rise up to 60°C (1 40°F), e.g. on the dashboard, windowsill or behind a glas panel, which is
exposed to high UV-Light or the sun. In this case the device or the vehicle can be damaged.
Damages, which require a repairing
Disconnect in the following cases the device from the USB port and contact an authorized repairing specialist or the dealer:
• Liquidity or any item came into the product.
• The product was exposed to rain or liquidity.
• The product fell down and is damaged.
• There are visible signs of overheating.
• The product does not work properly despite of correct operation.
Avoid using the device right after high thermal fluctuation. Condensation in the device might occur if you expose the device to high
thermal or humidity fluctuation. In order to avoid damages wait until the humidity is evaporated, before using it.
NOTE: If you bring the device from a cold into a warm or from a warm into a cold environment,
let the device take over the temperature before switching it on.
