3-32
Raychart 425 Chartplotter
➤
To receive waypoints and route lists:
1. Display the Waypoint List as previously described, then select
WPT/ROUTE TRANSFER
.
2. Select
RECEIVE WAYPOINTS
and press
ENTER
; the text changes to
STOP RECEIVING
and remains selected.
3. Initiate sending waypoints on the NMEA compatible equipment.
4. To stop waypoint transfer, press
ENTER
.
Note: If either the Waypoint List or Route List becomes full, a warning is
displayed and the operation is terminated.
3.7 Using Tracks
The Track function is used to mark an on-screen trail that the vessel has
followed, as if it had left a visible fixed wake.
While the track is turned on, it is recorded in the display unit’s memory.
You specify the interval at which track points are made and a line is drawn
on-screen between each point. Up to 2000 track points can be saved in
total.
The track remains on-screen, even following a Power off/on, until the
track is cleared.
Using the SmartRoute function, a track can also be converted to and
saved as a route which is automatically reversed, ready for use as a return
voyage.
This section describes how to:
•
Set up a track and specify the interval between track points.
•
Clear the current track.
•
Convert the track to a route (SmartRoute).
➤
To access the track controls:
1. From chart mode, press the PAGE key to display the chart set up
function bar (Figure 3-50):
Figure 3-50: Set Up Function Bar
2. Select
TRACK SET UP
to display the Track function bar (Figure 3-51):
D4694_1
Summary of Contents for Raychart 425
