Navistar Electrical Systems CV
Integration Guide
Page 55 of 84
Revision Date: 9/12/2019
7.
Rearview Camera Installation
Note: Navistar Dealers and truck equipment manufactures requiring instruction and
guidelines on the installation of reaview cameras on Navistar CV vehicles.
The following are guidelines intended to assist with the installation process.
Furthermore, compliance to all FMVSS rules and regulations are the strick
responsibility of the camera system integrator.
7.1. Mounting the Camera
Fabrication of brackets and, or mounts for the mounting of the camera is the
responsibility of the truck equipment manufacture. Mounting location should be
determined by case by case to maximize the field of view and miage display quality
requirement set fouth by the National Highway and Transportation Safety
Administration (NHTSA). The NHTSA has publishe test procedures available which
may be dounloaded to aid in dstablishing a mounting location that meets the
standards.
https://www.nhtsa.gov/
2019 and later Navistar CV vehicles:
It is the truck equipment manufacture
’s
responsibility to ensure FMVSS111
requlatory adhearance.
Regular Production Option (RPO) UVC provides the following content for facilitating
the installation of a rear-view camera.
Rear camera calibration installed at assembly plant
One camera unit complete with pigtail wiring
Fixed zero pitch mounting bracket
One wire harness extension
7.2. Camera Installation Guidelines
Install camer into the provided mounting bracket using the provided two
screws (not shown bu included).
Opimal position for the camera (using the included OEM bracket) is the
centerline of the vehicle at a height of 38
” off the ground, with zero
-inch
set-back from the rear most portion of the vehicle/body.
An allowable distance of two inches off the centerline of the vehicle and no
more than a range of 24
” to 48” off the ground with a
set-back distance of
no more than eight inches from the rear of the vehicle/body represents the
maximum distances with which the OEM bracket is capable of meeting the
requirements defined in FMVSS111. Note: by increasing the set-back
distance from the rear of the vehicle this additional distance will result in
the increase in the vertical range of the camera.
Other mounting locations and stragies requiring a different camera
mounting solution shall be the responciblity of the camera system installer.
Note: These components
are all shipped inside the
vehicle cab
