Operation
Adjustable Steering Column
1.
Steering Wheel
2.
Release Handle
If equipped with the optional tilting and telescoping steering
column, the steering wheel can be adjusted as follows:
•
Grasp the steering wheel with your right hand and unlock
the release handle with your left hand, by pushing forward
on the release handle.
•
Using both hands, grab the sides of the steering wheel
and adjust the telescoping feature to the desired position
and then the steering wheel tilt to the desired position.
•
Hold the steering wheel in the newly acquired position
with your right hand and pull the release handle backward
towards you, to the locked position, with your left hand.
•
Make certain the steering wheel is in the proper position
and the column is locked.
General Information
•
Start the vehicle in motion by utilizing the highest gear
speed in the transmission that will enable the engine to
easily pull the load without slipping the clutch. Accelerate
smoothly and evenly to engine rated speed.
Rapid
acceleration will result in high fuel consumption.
•
When approaching a hill, depress accelerator smoothly to
start the upgrade at full power, then shift down as needed
to maintain vehicle speed.
•
Prevent over-speeding of the engine when going down
long and steep grades.
The governor has no control
over engine speed when it is being pushed by the loaded
vehicle.
Operate in a gear that will permit an engine
speed below the Maximum Governed Speed or High-Idle
RPM (no load).
146
Summary of Contents for ProStar+
