Maintenance Intervals and Specifications
Lubrication and Fluids Charts
NOTE: Components requiring lubrication and fluid check
and fill diagrams are typical representations.
Lubrication Notes
CAUTION
To prevent property damage, avoid unapproved
lubricants,
which
can
cause
premature
component failure. Refer to the Lubricants and
Sealer Specification table for proper lubricants.
•
Wipe clean all dirt and debris from grease fittings before
applying grease. If the fitting is not cleaned, dirt can be
pushed into the component with the grease. Always fill
grease to the point where old grease and contaminants
are forced out from the part and only new grease comes
out. If a fitting does not accept lubrication due to damage
or internal stoppage, replace with a new fitting. Remove
excess grease from fittings and other surfaces after
applying grease.
•
Some vehicles may have optional remote mounted
grease zerks for the clutch cross-shafts. These fittings
reduce service time by providing convenient access to
clutch cross-shaft bushing grease zerks. Grease may
be applied through two remote mounted grease zerks
mounted to the bottom of the transmission bell housing.
Fluid Check and Fill Notes
CAUTION
To
prevent
property
damage,
use
only
recommended viscosity engine oil. Refer to the
Engine Operation and Maintenance Manual for
engine oil specifications.
•
Wait 15 minutes after shutting off the engine before
checking the oil level. This gives the oil time to drain
back to the oil pan.
•
Clean all caps and fill plugs prior to removal to prevent
dirt and debris from entering system.
•
Filling the power steering fluid above the MAX COLD
mark when cold will result in fluid overflow when hot.
•
If engine is cold and coolant is above the MIN / ADD line,
no additional coolant is needed. Excessive filling when
cold can cause tank to overflow when hot.
•
When checking the axle hub fluid level, maintain fluid level
to fill line on hubcap.
•
Check the rear axle(s) vent for blockage. Blockage can
cause excessive pressure in the axle and create leaks.
254
Summary of Contents for ProStar+
