Inspection Guide
Tractor Inspection
Preparation
NOTE:
Perform
the
following
procedures
prior
to
conducting the pre-trip inspection.
•
Set parking brakes.
•
Turn on parking lights and hazard lights.
•
Unhook the hood latches, raise the hood, unlatch and
lower the optional Tilt-away bumper.
•
Check under the vehicle for oil, fuel, or other fluid leaks,
or other signs of damage.
•
Use pull cables or open drain cocks to allow air tanks to
expel any existing water. Release pull cables or close
drain cocks.
•
Install wheel chocks on tractor and trailer, if attached.
•
Start the engine and allow the air pressure to build up
to normal operating pressure of 115 - 130 psi (793 - 896
kPa). Stop engine.
Exterior Lights Check
Perform an automatic check of all exterior lights by doing the
following steps:
1.
Place the ignition key in the ON or ACC position, place
the transmission in Neutral, and set the parking brake.
2.
Press the WORK LIGHT switch for approximately two
seconds before releasing to activate this feature.
3.
The exterior light check will now cycle all vehicle lights
except the backup light(s). The test flashes the exterior
lights on and off in three, 2-second cycles. The first
2-second period illuminates park lights (clearance,
identification, side marker, and license plate lights),
turn signal lights, low beam headlights, and fog lights.
The second 2-second period illuminates park lights
(clearance, identification, side marker, and license plate
lights), high beam headlights, brake lights, and work
lights. The third 2-second period turns off all lights. This
cycle repeats until deactivated by the operator.
4.
Walk around vehicle and inspect illumination of lights.
5.
To cancel this feature, do one of the following: press the
brake pedal, manually turn on any external light, turn the
key to OFF, or release the parking brake. The feature
will automatically cancel approximately 10 minutes after
activation if not deactivated by the operator.
6.
To check the backup lights, there need to be two
people. Keep the engine running. Depress the clutch (if
applicable) and select reverse while the second person
observes backup light operation.
28
Summary of Contents for ProStar+
