Inspection Guide
Right Rear of Tractor
1.
Brake Chamber and Hoses
2.
Slack Adjuster
3.
Brake Lining and Drum
4.
Wheel and Lug Nuts
5.
Tires
6.
Hub
7.
Spring Suspension
8.
Torque Rods and Shock Absorbers
9.
Air Suspension (if equipped)
10. Frame
WARNING
To prevent property damage, personal injury, and
/ or death, if wheels or tires must be changed,
obtain expert tire service help.
Mounting and
demounting of tires should only be performed
by qualified personnel using necessary safety
procedures and equipment.
1.
Brake Chamber and Hoses: Check for cracked, worn or
frayed hoses, and for secure couplings. Check to see
that the brake chambers are not cracked or dented and
that they are securely mounted. Check for broken, loose
or missing parts.
2.
Slack Adjuster: Check slack adjuster and chamber push
rod travel. When pulled by hand, push rod should not
move more than approximately 1 inch. Angle between
push rod and adjuster arm should be approximately 90
degrees when brakes are applied.
3.
Brake Lining and Drum: With brakes released, check
to see that brake linings (where visible) are not
worn excessively thin [less than 1/4 inch (6 mm)] or
contaminated by lubricant.
4.
Wheel and Lug Nuts: Check for damaged or bent wheel.
Check to see that all lug nuts are present and not loose
(look for rust trails around nuts). Ensure that no cracks
or damage are present at wheel mount holes.
40
Summary of Contents for ProStar+
