10
Installation
Installation
Before starting, review the precautions on page 5.
To install the VideoMate 2250, proceed as follows:
1. Check the voltage setting before powering on. Make
sure that the setting above the power cord is correct
for your voltage. Also, check the fuse behind the
voltage setting to make sure it is correct for your
country.
2. Plug in the power cable.
3. Connect the cable to your peripheral equipment (TV
monitor, video projector, etc.). The connection for
Composite Video and genlock is BNC and a 4-Pin
MiniDin for Y/C S-Video.
4. Load the slide tray and “power-up” all equipment.
5. Press the forward button to advance to the first slide.
6. When the projector is powered-up focus and iris are in
automatic modes. For manual focus adjustment, set
the auto focus switch to OFF. For manual iris adjust-
ment, press either of the iris buttons.
7. Set the computer input switch to either:
ON:
For RS232 control of camera functions
Through the P-Bus in 9-pin connector.
OFF: For manual operation of camera functions
(i.e. iris).
8. Press the zoom button to select the correct picture
size for your presentation.
9. Adjust the iris and focus to produce a satisfactory
image. These are push button controls that change
+/- with every push of the button. To return to auto iris
mode, press the + and – buttons simultaneously.
10. Press standby to stop your presentation and remain in
the current spot. Press standby again to regain power.
