NAVITEL MSR200
| 11
EN
Device functions
Video
Connect the device to an external power supply and it will start recording automatically (indicated by the
flashing blue light). Press the OK button to stop recording (the blue light will become steady). Press OK again
to record another video. Each video will be saved automatically.
Photo
In Video Recording mode (STBY), press the Power button to enter Capture mode, press the OK button to take
a photo (it will be saved automatically).
Playback
In Video Recording mode (STBY), press the Power button twice to enter Playback mode; press the Up and
Down buttons to select a file; press the OK button to play a file. During playback, press OK to pause/unpause;
press the Up and Down keys to fast forward/rewind.
Record audio
Record video with or without sound.
Lock file
In Video Recording mode (REC), press Power to protect the current recording. A key symbol will appear at the
bottom of the screen. In Playback mode, select a file, press Menu and select Protect, then Lock Current or Lock
All. Protected files cannot be deleted or overwritten. Select Unlock Current / Unlock All to remove protection.
Loop recording
This setting allows saving the recording in separate files every few minutes. For example, if set to
5 minutes, 1 hour of footage will be saved as 12 five-minute fragments. If the memory card is full, all
unprotected files will be overwritten in the order they were created.
G-sensor
If the vehicle is hit by something, the DVR will automatically lock the current video.
Parking monitor
In shutdown state, if vibration is detected, the device will turn on automatically and start recording. The file
will be protected (locked). If nothing happens for over 10 seconds, the device will shut down.
Motion detection
When an object is moving the device will automatically start recording. If the object does not move for more
than 5/10/30/60 seconds, recording stops.
Stamp
This function adds date stamp to the record.
Battery
Red indicator lights up when the device is plugged into an external power supply; as the battery is charging,
the red light will gradually dim; the red light going out means the battery is full.
Screen Saver
The device can automatically shut off the screen to reduce power consumption; time interval can be set in
the Screen Saver menu.
