Map page
39
© 2003 - 2013 ... Naviter d.o.o.
Tap on a Waypoint, then tap OK to start navigating to the selected point.
3.1.2
Airspace
A tap on an airspace brings up a dialog where you can read the information on the airspace.
By default this page shows all airspace within a certain margin around the area of your tap. You can
quickly change the status of any of these airspaces by using the buttons for disabling an airspace for
Always, Today, 5 minutes
or turning them back on with the
Activate
button.
By turning on the
Show all
checkbox all airspace from the airspace file is listed. This helps you turn
remote airspaces on or off. It also helps you to turn several airspaces off quickly. Note that Multiselect
feature works in this dialog meaning that you can select as many airspaces as you wish.
Summary of Contents for Oudie 3
