Version 14.03.2022
HW 16-(V65)
CI-VL1-NG4-HU
P
a
g
e
12
2.5.1.
Audio-switch and audio insertion
This interface is only able to insert video signals into the factory infotainment and switch
audio signals. If an AV-source is connected, audio insertion must be done by factory audio
AUX input or FM-modulator. The inserted video-signal can be activated simultaneously to
each audio-mode of the factory infotainment.
Connection of 1 AV source
If only one AV-source shall be connected, it is possible to connect the audio output of the
AV-source directly to the point of audio-insertion (e.g. to the factory AUX input).
Connection of 2 AV sources
This interface has an integrated audio switch for switching the audio signals. If two AV
sources are connected, the audio output of the AV sources is connected to the point of
audio-insertion via the optionally available audio cable CAB-FV-AUDIO (e.g. to the factory
AUX input). When switching the video interface from AV1 to AV2, the audio signal is also
switched automatically.
Attention:
The audio cable CAB-FV-AUDIO shown in the diagram is not included in the
delivery contents and is optionally available!
Pin-assignment white 12pin insert of the vehicle’s Quadlock
No liability for vehicle wire colors and pin definition! Possible changes by the vehicle
manufacturer. The given information must be verified by the installer.
Cable colour
Assignment
●
Yellow
Audio left Pin 4
●
Blue
Audio right Pin 3
●
Brown
Ground Pin 5
