Version 04.05.2021
HW:CAM(V98/99/100)/(V45/46)
RL4-MBN6
P
a
g
e
15
2.3.4.
Installation with connection to CAN bus or analogue (without CAN bus)
The RL4-MBN6 can be integrated via CAN bus as well as operated in analogue mode without
CAN bus.
When integrated via CAN bus, the interface is switched on by the vehicle’s CAN
-Bus and the
R-gear signal is usually recognised, too (not all vehicles).
With the MBUX with 7 inch monitor, some vehicles can display guide-lines. To avoid CAN bus
incompatibility or to comply with vehicle manufacturer policies, an analogue connection
without using the vehicle’s CAN
-BUS is also possible. In this case, via +12V switch inputs, the
interface is switched on and switched to the rear-view camera input.
If connected analogue, guide-
lines can’t be shown
.
2.3.4.1.
Connection points/CAN
–
all vehicles
Attention:
The two CAN wires may only be connected at the following specified points.
Tapping the CAN information at other points can cause malfunctions.
Head Unit
Type 1
with
pink-bordeaux
Double-Fakra
Alternatively, the plug&play connection can be made with article
PNP-MBUX31P
.
Head Unit
Type 2
with Double-Fakra
Alternatively, the plug&play connection can be made with article
PNP-MBUX31P
.
** The CAN bus colours on the vehicle can also be yellow/
white
and yellow!
Pin-assignment RL4
10pin Power/CAN
Pin-Belegung
Type 1
black 26pin
locking connector
•
CAN High blue
•
•
Pin 7 purple white
**
•
CAN Low grey
•
Pin 20 purple **
•
+12V
battery yellow
•
Pin 14 red
•
Ground black
•
Pin 1 brown
Pin-assignment RL4
10pin Power/CAN
Pin-assignment
Type 2
white 31pin connector
•
CAN High blue
•
•
Pin 15 purple white **
•
CAN Low grey
•
Pin 22 purple **
•
+12V
battery yellow
•
Pin 1 red
•
Ground black
•
Pin 6 brown
