M-Nav 760 | User Manual
11
3.3
Add the M-Nav 760 to the Docking Cradle
IMPORTANT:
Check the M-NAV 760 internal battery switch is ON before you add the M-Nav
760 to the docking cradle. You should not need to touch this switch again after it has been
switched ON.
Insert the mini-USB (attached to the cable already fed through the dashboard from the Qube
tracking device) into the mini-USB port at the back of the docking cradle.
Put the bottom of the M-Nav 760 into the docking cradle, and then push the M-Nav 760 gently
back until it snaps into place with an audible click.
IMPORTANT:
The M-Nav 760 must be in the docking cradle and connected to the Qube
tracking device in order for you to report your driver status, send and receive messages and
otherwise communicate with your fl eet administrator through the OnlineAVL2 application.
The start up screen will display automatically. See section 4.
Use the adjustment knobs on the docking cradle to change the viewing angle and the tilt angle,
if necessary, to give a comfortable viewing position.
If you are leaving the vehicle for a while, we recommend that you remove the M-Nav 760 from the
docking cradle and store it in a safe place.
Note:
The M-Nav 760 will charge only when connected to a Qube in a standard vehicle
installation or AC adaptor supply. It will
not
charge when connected to a standard USB
connection through a PC or similar.
