9
TRACKER 5100/5100i/5500/5500i Installation and Operation Manual
NAVMAN
2-1 Turning on and off / auto power
Auto power
If the TRACKER is wired for auto power (see section
15-3), then the TRACKER automatically turns on and
off with the boat power, and can not be turned on or
off manually.
Turning on manually
If the TRACKER is not wired for auto power, turn the
unit on by pressing
.
Startup
After the TRACKER has been turned on:
1
The unit displays a title display for a few
seconds, then beeps again and displays a
navigation warning.
2
If necessary, adjust the display to be easy to
read (see section 2-3).
Read the warning and press ENT.
3
The satellite display is shown.
Either wait for the GPS receiver to start up
and the status to change from ‘acquiring’ to
‘GPS fix’ (see section 7).
Or press ESC.
4
The TRACKER chart is displayed (see section 3).
Turning off manually
If the TRACKER is not wired for auto power, turn the
unit off by holding down
until the display turns off.
After you have turned the TRACKER on, it shows
the satellite display until the GPS receiver gets a GPS
fix, then displays the Chart. The Chart is the display
that you will normally use for navigation.
2-2 The main displays
Fuel (fuel computer)
Section 4
Waypoints
Section 9
Tides (tide chart)
Section 8
Satellite (GPS data)
Section 7
Highway (boat path)
Section 6
Data (numeric data)
Section 5
User card
Section 11
Routes
Section 10
About
Section 12
The main displays
See:
Display menu
Chart
Fuel
Data
Highway
Satellite
Tides
Waypoints
Routes
User C-card
About
Press ESC to
return to
chart display
To use one of the other main displays, press DISP
for the display menu and select a display to use.
To return to the chart display, press ESC.
Press DISP for
display menu
To select a display:
i press
or
to
highlight the display
ii press ENT to go to
the display
Chart (navigation)
Section 3
