NAVMAN
TRACKER 5507/5607
Installation and Operation Manual
42
12 User card window
A C-MAP™ user card is an optional plug-in card
that can store data files (see section 1-3). There are
three types of files: waypoints, routes or a track.
To go to the user card window, press
,
select
More
, then select User card.
Note:
1 Before using a user card, remove any chart
card and plug the user card in. When you
have finished with the user card, remove
the user card and replace the chart card
(see section 1-3).
2 The older 5 volt cards are not supported.
The user card window has:
File list
A list of the files on any user card in the 5507/5607.
If there are more files than will fit on the display,
press
or
to scroll up or down a page at
a time.
Waypts, Routes
The number of waypoints and routes currently in
the 5507/5607.
Track 1 to Track 5
The number of points in tracks 1 to 5 currently in
the 5507/5607.
Note:
1 To save 5507/5607 data onto the user card,
use the Save command (see below).
2 Data stored on the user card and shown on
the file list is not available to be used by the
5507/5607 until loaded into the 5507/5607
with the LOAD command (see below).
Saving data to the user card
This saves all the 5507/5607’s waypoints, all the
5507/5607’s routes or one of the 5507/5607’s
tracks to one file on the user card.
1 Press
and select
Save.
2 Select
Waypts, Routes
or Tracks.
3 For
Tracks,
select the track number to
save.
4 The new file is created. Change the name if
required. The new file appears in the
file list.
Loading data from the user card to the
5507/5607
This loads one file from the user card to the
5507/5607:
A waypoints file: The new waypoints are
added to any existing waypoints in the
5507/5607. If a new waypoint has the same
name as an existing waypoint but has different
data, the 5507/5607 displays both waypoints.
Select:
Skip:
Do not load the new waypoint.
Replace
: Load the new waypoint and
replace the existing one.
Skip all:
Do not load any new
waypoints which have the same names as
existing waypoints.
Rplc. all:
Load all new waypoints
which have the same names as existing
waypoints; the new waypoints replace the
existing waypoints.
Summary of Contents for Tracker 5507
Page 2: ......