23
LINE ADJUSTMENT
The cables may stretch and contract during use. They should then be checked and properly adjusted (if adjustment is
available on your model). To do this:
1.
loosen the small locking nut
1 (Fig. 22)
and then depending on your needs:
2.
turn the adjusting nut
2 (Fig. 22)
counterclockwise: the cable is shortened,
3.
turn the adjusting nut
2 (Fig. 22)
clockwise: the cord will be extended.
GREASING
The swivel wheel bearings should be lubricated by introducing a small amount of aerosol lubricant directly onto the bearing
25 (Fig. 23
).
To lubricate the rear drive wheel rack
8 (Fig. 1)
you should:
1.
Remove the rear wheel hub cap by turning the hub cap counterclockwise.
2.
Unscrew the drive wheel nut with a 13 mm wrench.
3.
Remove the drive wheel from the axle.
4.
Remove the Seger ring
26 (Fig. 24)
and then slide the drive rack off
27 (Fig. 24)
, from the gear shaft
29 (Fig. 25)
.
5.
Sprocket, drive carrier
28 (Fig. 24)
and the gear shaft must be cleaned of grease residues and lightly grease the
above elements. The recommended grease for this operation is NAX bevel gear grease.
CAUTION! Lubricate the gear wheel from the inside 27 (Fig. 25). Do not lubricate the outer rim on the
sprocket and the drive wheel.
6.
Refit the entire mower drive mechanism in reverse order.
TRANSPORTATION
PREPARATION FOR TRANSPORT
Before transporting the mower, remove oil, then: cool the engine, remove fuel from the tank, carburettor and fuel
lines.
The device can only be transported in the working position, i.e. at an angle of up to 15 degrees above the level.
The handle may be folded.
Attention! Be careful when folding or unfolding the handle, as the cables may be damaged. Damaged cables
can cause the mower to malfunction and in some cases reduce the safety of use of the device.
DEVICE ASSEMBLY DIAGRAMS
The assembly diagram of the device is available on the website
9 Fig. 26.
Summary of Contents for NAX 2000S
