NAX 3001S Manual Download

Page: 43 / 144

MOWING HEIGHT SETTING

Attention! Before changing the cutting height, stop the engine and disconnect the spark plug cable.

To set the desired cutting height, change the position of the adjustment lever

24 (Rys.(Fig.) 10)

located on the housing of the mower.

You can choose from 6 different cutting heights in the range of 25 - 75 mm.

INSTALLING THE GRASS BASKET

Raise the mower basket cover

23 (Rys.(Fig.) 2).

Insert the basket

7 (Rys.(Fig.) 1)

attaching the hooks at the inlet to the basket on a rod designed for this purpose at the mower

outlet cover

(Rys.(Fig.) 11),

then lower the cover.

Make sure the hooks are attached correctly.

Warning!

Often check the technical condition of the grass basket. If any parts are worn or damaged, they must be replaced

with new parts that are available at authorized service centers.

EMPTYING THE GRASS BASKET

Warning!

Stop the engine before emptying and removing the basket.

Basket full indicato

(Rys.(Fig.) 2)

allows you to quickly assess the level of basket filling. If the indicator plate is raised while the

mower is running, it means that the basket is not full yet. If the indicator plate is raised while the mower is running

(Rys.(Fig.) 12 A)

it means that the basket is not full yet. If the indicator plate is in a horizontal position during the mower's operation

(Rys.(Fig.) 12 B),

it means that the basket is full and should be emptied.

SETTING THE FRONT WHEELS

Due to the special design of the front wheels, the mower is extremely manoeuvrable. Wheel alignment is set when the clamping device
snaps into place

19 (Rys.(Fig.) 13)

. If we want to change the wheel position:

lift the bracket to release it,

put the wheel in a new position,

snap the mounting brackets back into place.

In order for the front wheels to move freely, the clamping brackets must be raised

19 (Rys.(Fig.) 13)

and do not put them in the hole, but

place them on the plate next to it

(Rys.(Fig.) 13 pkt. A)

CLEANING THE CUTTING UNIT CABINET

Warning!

When the engine is running, the cutting blades rotate.

After finishing work, thoroughly clean the entire device.

Stop the engine and disconnect the spark plug wire before cleaning the housing.

Empty the fuel tank before cleaning.

Without tilting the mower to the side, lay it on the ground so that the front wheels are in the air.

Clean the underside of the mower with a brush and water.

Do not use high-pressure cleaning devices, as high-pressure water can break the paint protection of the housing. Do not use intensive
cleaning and washing agents, e.g. aggressive detergents, they can damage plastics and metals, which may result in deterioration
of the device's safety.

The second way to clean the housing is to use the housing cleaning system.
After connecting the hose to a special quick coupler that is already mounted in the mower housing and unscrew the water, start the mower.
The device is cleaned during the rotation of the knife, on which a strong stream rinses out flushing residues of grass.

(Rys.(Fig.) 14)

MOUNTING THE SIDE DISCHARGE CHUTE

To mount the side discharge chute:

open the side ejector cover

18 (Rys.(Fig.) 2)

(To unlock the cover, first turn the axle cover

(Rys.(Fig.) 16A, B)

push in the side discharge chute

20 (Rys.(Fig.) 2)

as shown in

Rys.(Fig.) 16C,

rest the side ejection cover on the side discharge chute