5. Basic Disc, USB or MMC/SD Operation
5.1 Begin playback
1. Press the POWER button briefly to turn on the DVD player.
2
After turning on the DVD player, please turn on the monitor, and ensure that
the video output of the monitor is the video input from the DVD player
connected with the monitor.
?
Common Question
Q: There is not anything is displayed on TV screen when the DVD player is
turned on. How to solve the problem?
A: Ensure that the TV was set to right video input(not TV channel); for
example, if you make VIDEO1 INPUT of TV and DVD player connected
with each other, then you need set TV to VIDEO1.
. Press the EJECT button to slide down the front panel.
3. Insert a disc into the Disc Compartment(Label surface up), then the
front panel will slide back to the previous angle.
! NOTE
1. For some discs that are seriously scratched or poor manufacturing or
recording quality, it may not play.
2. If the player can not read disc under normal condition, please try to
eject and reload the disc again.
3. Remark:
1) In addition to normal CD and DVD, this unit supports to play CD-R,
CD-R/W, DVD-R and DVD-R/W as well; however, depending on the
conditions of the recording equipment, recording program or the disc
itself, some CD-R, CD-R/W, DVD-R or DVD-R/W may not play.
2) When dealing with CD-R, CD-R/W, DVD-R or DVD-R/W recording,
too high recording speed may result in poor signal quality and therefore,
it is recommendable to select as lower as possible recording speed.
During slow forward, press the PLAY button to resume normal playback.
The function is only for video.
6
If the unit is currently running DVD/VCD disc, press the STEP button
consecutively to display the still frame forward with step by step.
Press the PLAY button to resume normal playback.
6
6
1.
In the mode of DVD disc playback:
Press the RPT button to select RPT CHAPTER, RPT TITLE and RPT
ALL.
2.
In the mode of VCD(PBC OFF)/CD disc playback:
press the RPT button to select RPT 1, RPT ALL.
When it is in the state of PBC ON, during VCD disc playing, the RPT
button are not available.
3.
In the mode of MP3/WMA disc playback:
Press the RPT button to select RPT 1, RPT DIR, RPT ALL.
6
Press the
button if you want to repeat a specific segment on a disc
that you define:
1.
Press the
button at a point (A) where you want it to be the start point
of the repeat segment. Press the
button again at a point (B) where you
want it to be the terminal point of the repeat segment. Then it will play the
segment repeatedly.
2.
To cancel the A-B repeat mode and resume normal playback, press the
button for the third time.
.3 Playback with still frame
.4 Playback Repeatedly
.4.1 ONE/ALL Repeat
.4.2 A-B Repeat
A-B
A-B
A-B
A-B
Note:
During VCD/MP3/WMA/CD playback, points A and B must be within the
same track.
During DVD playback, points A and B can be selected from different chapters.
PDF created with FinePrint pdfFactory trial version
http://www.pdffactory.com
