Manual Instructions for Gas Wok Ring Table
NAYATI
AMICUS
14
9. If the appliance has not preset to the gas availability, you must convert it into another gas type.
Authorized personnel must do this by referring to the technical data (primary air regulation and
nozzle table), changing the main burner and pilot burner nozzles. Once this has been done, a
new rating data plate should be affixed to the new data by referring to the new gas type.
•
Position and Fixing
Authorized personnel must do the installation. Install the appliance according to National
Safety Standard about gas-heated standard. Place the appliance in good ventilated room with
permanent ventilation ducts to guarantee sufficient exchange of air and keep the work place
healthy. If the Gas Wok Ring Table not connected to a flue, it is recommended to install it
under efficient hood, which could evacuate burned gases and cooking steams. Make sure that
any object around or under Gas Wok Ring Table does not obstruct air volume required for
combustion. Put away any flammable materials near Gas Wok Ring Table. When the
appliance is freestanding, keep a distance at least 10 cm from side, and rear walls. Especially
when the appliance close to wall and does not protected with fire-resistant materials made.
Install the appliance separately or side by side with other appliance according to recommended
range. Put Gas Wok Ring Table on solid, flat, and horizontal floor. Adjust the height of the four
feet by using brackets. Before turn the appliance ON, remove the protective film. Remove any
adhesive with appropriate solvent. Eliminate all packaging material according to national laws.
Warning!
NEVER USE FREE FLAME TO FIND GAS LEAKS!
20140227