Getting Started with MAXserver Access Servers
0038
114
Example
The following command shows how to disable RARP as a dump protocol in
the primary initialization record:
XYPLEX>> DEFINE SERVER DUMP PRIMARY PROTOCOL RARP DISABLED
Assigning IP Addresses
You need to configure the following IP addresses to establish Internet access
for MAXservers.
·
The IP address for the host on the network where the software load
image file resides.
·
The IP address for the access server.
·
The IP address of a gateway on the network that the access server uses
to gain access to the Internet load host ( if your network configuration
includes a gateway).
·
The IP address of the host on the network where the image file resides.
Internet Load Host
The Internet load host specifies the IP address of the host on the network
where the software load image file resides. The default is 0.0.0.0.
Use the following command to define the Internet access server. This
address is used by the Internet load host during DTFTP loading. The
default is 0.0.0.0.
DEFINE SERVER LOAD [record|ALL] IP [LOAD] HOST ip-address
