Getting Started with MAXserver Access Servers
0038
129
13.
The CARD light goes ON for approximately 15 seconds if the unit is
loading from a flash card. (The MAXserver is accessing the flash card.
Do not remove the card while the CARD light is ON.)
14.
The RUN light flashes rapidly and the LAN light flashes as Ethernet
packets are received. (The MAXserver is loading, or trying to load,
software.)
15.
When loading from a flash card, or when using another MAXserver as a
load server, Port lights 8 - 1 go ON, sequentially. Then, lights 8 - 1 go
OFF. (The MAXserver has finished loading the software image, and is
decompressing it.)
16.
When the MAXserver has finished loading its software, the RUN light
flashes slowly and the LAN light flashes as Ethernet packets are
received.
Startup Error Codes
If front panel lights do not behave as described in the previous section when
you power up or initialize the MAXserver, the unit might be displaying an
error code. A special pattern of diagnostic codes indicates that a hardware or
software error has occurred. Figure 35 shows how the diagnostic code;
appears on the MAXserver front panel lights.
+
Only Port LEDs 1 through 8 are used to display self-test error codes.
