Getting Started with MAXserver Access Servers
0038
133
Use the following command to display the contents of the SYSTEM
directory:
SHOW SYSTEM PARAMETERS
Network Loading Problems
Problem: The MAXserver does not appear to load from the network, or is
slow to load from the network.
Correct Operation: The load server downloads a software image and
(optionally) parameters to the MAXserver, over the network, whenever the
unit is powered on or re-initialized.
After the software and (optionally) parameters have been downloaded from
the load server, the RUN light should blink once every second. Then, if you
type several <RETURN>s at a terminal connected to any serial port, the
following message should appear:
WELCOME TO THE XYPLEX ACCESS SERVER.
ENTER USERNAME>_
Possible Solutions: The MAXserver generates several messages during
the load process, which can help you resolve loading problems. To see the
messages, press <RETURN> several times at a terminal connected to a
MAXserver serial port, when the unit begins the loading process. (When you
do this, the serial port adjusts to the communication speed of the terminal.
This process is called autobauding.) The port light should go ON when you
press <RETURN>.
If you type <CTRL><T> now, the unit will display the load server offer table
when it receives load offers. (Only one <CTRL><T> is required.)
