12
2
Overview
2.3 Button Operation and Mode Transitions
Operate the buttons on the front of the unit to rotate the output shaft and change modes.
Press and
hold
Manual Operations Mode
Lights up in green → white
Flashes in white
Unit Registration Selection Mode
Press and hold the
button for 3 sec. or more
Green → White → Yellow
↔ Blue (flashes alternately)
Press
Press
Lights up in blue
Lights up in yellow
Press
Press
Terminating
resistor setting
"ON"
Terminating
resistor setting
"OFF"
Terminating Resistor Setting Mode
Green → Light blue
↔ Purple (flashes alternately)
Flashes in purple →
Green (Normal mode)
Flashes in light blue →
Green (Normal mode)
Switches the terminating resistor setting on/off.
Factory default settings are -A (loose wires type) is set to
"OFF" and -B (connector type) is set to "ON".
Select either wireless or wired unit registration.
This is the standby status of
setup execution.
Wait approximately
10 sec. (no operations)
after completing settings or
press the button
Wait approximately 10 sec.
(no operations) or press the
button
Press the button
After unit registration is
completed or press the
button
Press and hold the
and buttons at the
same time for 3 sec. or
more
Normal Mode
Lights up in green
* For more details regarding the unit registration, please refer to the Dedicated Software (EPU-COM) Instruction Manual.
Wireless Unit
Registration Mode
Wired Unit
Registration Mode
Press and
hold
Output shaft rotates
in the CW direction
Output shaft rotates in
the CCW direction
Flashes in white
