NCast Presentation Recorder Reference Manual
Disable this selection if access to the network time servers is not available (closed network) or if the unit is
being used in a temporary location with a standalone hub or router (e.g. a tradeshow, conference or demo).
Bootup time will be substantially reduced if the system does not wait for a response from non-existent time
servers.
3.1.9. Serial Number and Revision Information
At the bottom of the Unit Options page internal system information is listed including:
•
Serial number of the hardware unit
•
Hardware architecture in use and firmware revision numbers
•
Software release revision and date for firmware and digitizers
•
System date and time
3.1.10.Configuration/Reset Buttons
On the right side of the web page are six buttons which may be used to configure, restart or reset the unit:
•
Shutdown – Powers down the unit and is recommended as the proper means to turn off a
Presentation Recorder if it will be idle for some time or is to be moved or reconfigured. All operating
parameters will be properly saved and restored.
•
Reboot – Shuts down and then restarts the unit. This operation may be needed to clear problems
after a power brownout or other unexpected glitch.
•
Date & Time – Controls setup of Date & Time and access to internal or external time servers.
•
Factory Defaults – All operating parameters are reset to the Presentation Recorder’s initial factory
configuration. Nothing is saved and the reset is irreversible.
•
Export Settings/Import Settings – Export or Import ALL configuration settings for this unit.
3.2. P
ASSWORDS
The Passwords page provides for entry of four different password types to control access to the Presentation
Recorder.
NCast Corporation
Revision 1.1
Page 18
