Power Setup
Printer Setup
Parts Included
•
Device
•
Power cord (inside
device)
•
Stylus and Holder (inside
device)
•
Packing slip
•
Quality testing labels
•
Quick Start Guide
NC DCG 09 002 (4/21)
1. Connect power cord to back
of the device and to an outlet.
Toggle master power switch to
illuminate green and charge the
touchscreen for 1 hour.
2. Open the case cover to reveal
the printer(s). Gently separate the
two black arms and insert label roll
unrolling from the top with black
lines facing down.
3. Press the blue/black tab to
release the lever. Extend the labels
over the edge of the opening and
close lever to snap in place. Labels
will automatically advance and
cut to calibrate. Repeat for second
printer (if applicable.) Close
case cover.
DateCodeGenie
®
X Series Quick Start Guide
models X2, X22, X23, and X33
Scan this QR Code
to watch the
setup video
