Installing Additional Memory
5-4
Installing Optional Equipment
Disassembling the Base
1. Remove all cables connected to the
NC
. If a
PCMCIA
card is installed,
remove it.
2. Place the
NC
with the top up and the front facing you (preferably, on an
anti-static mat).
3. Use your finger to release the clip on the front control panel and remove
the panel. See Figure 5-2.
4. Use a small flat-blade screwdriver to release the two tabs located on the
front of the
NC
, as shown in Figure 5-3.
Figure 5-2 Removing the Front Control Panel
Figure 5-3 Releasing the Tabs
Summary of Contents for Explora 700
