07
NCM
MOSCOW PLUS 48V
INSTALLATION AND ADJUSTMENT
Then remove the top cap
(and washers, if adjustments
to stem height are necessary).
During installation, make
sure that there is no gap
between the head tube and
the front fork.
S5
1. Remove the upper screw of the fork steerer tube.
M
S5
S5
3. INSTALLATION AND ADJUSTMENT
3.1 Handlebar and Stem Assembly
2. Put on the conical washer, 2 thick washers and 1 thin
washer on the exposed steerer of the fork.
3. Install the handlebar and stem as shown in the above
image, making sure none of the cables are twisted or too
tight (you may have the handlebar twisted). Put the top
cap with screw into the stem and fasten the screw (or the
ball-bearings could get damaged) to secure the stem down
onto the headset.
4. Align the handlebar vertically with the wheel (you may
need to loosen the screw from step 3 to make small
adjustments) and tighten the bolts on both sides of the
stem.
Summary of Contents for PRAGUE
Page 1: ...PRAGUE 36V OWNER S MANUAL Important information enclosed please read before your first ride...
Page 30: ......
Page 31: ......