Additional UPS Features
32
NCR 4072 UPS Site Preparation, Installation, and Operation Manual
S
05147374 Rev C
Uncontrolled Copy
Network Transient Protector
The Network Transient Protector, shown in Figure 21, is located on the
rear panel and has jacks labeled IN and OUT. This feature accommodates
a single RJ-45 (10BaseT) network connector.
Low voltage models can also accommodate an RJ-11 telephone
connector that provides protection for modems, fax machines, or other
telecommunications equipment. As with most modem equipment, it is
not advisable to use this jack in digital PBX (Private Branch Exchange)
environments.
NOTE
DO NOT connect any telephone or fax/modem equipment to the
230V models; only network protection is available for 230V models.
1.
Connect the input connector of the equipment you are
protecting to the jack labeled IN.
2.
Connect the network or telephone cable (low voltage models
only) to the jack labeled OUT.
OUT
IN
IN
OUT
NETWORK TRANSIENT PROTECTOR
Figure 21. Network Transient Protector
