7197 Series II Owner’s Guide
Chapter 6: Commands
August
2011
86
m
Feed and Cut Mode
0, 48
Full cut (no extra feed). Partial cut on the Sam.
1, 49
Partial cut (no extra feed).
65
Feeds paper to cutting po (
n
times vertical motion unit),
and cuts the paper completely.
66
Feeds paper to cutting po (
n
times vertical motion unit),
and performs a partial cut.
Range of
m
:
0, 48; 1, 49
65, 66 (when used with
n
)
Range of
n
:
0 - 255
Default of
n
:
0
Default of
m
:
0
Selects a mode for cutting paper and cuts the paper. There are two formats for this
command, one requiring one parameter
m
, the other requiring two parameters,
m
and
n
.
The format is indicated by the parameter
m.
Formulas:
n
times the vertical motion unit is used to determine the cutting position to the
distance that the paper is fed.
Example:
MSComm1.Output = Chr$(&H1D) & Chr$(&H56) & Chr$(m) & Chr$(n)
Exceptions:
If
m
is out of the specified range, the command is ignored.
Print Test Form
ASCII:
US t
Hexadecimal:
1F 74
Decimal:
31 116
Prints the current printer configuration settings on the receipt.
Disabled in page mode.
Example:
MSComm1.Output = Chr$(&H1F) & Chr$(&H74)
Exception:
Summary of Contents for 7197 II SERIES
