7197 Series II Owner’s Guide
Chapter 6: Commands
August
2011
82
Perform Partial Knife Cut (Previously command was full knife cut)
ASCII
: EM
or
ESC
i
Hexadecimal
: 19 or 1B
69
Decimal:
25 or 27
105
Cuts the receipt, leaving .20 inch (5 mm) of paper. This command is implemented the
same as Partial Knife Cut (1A, 1B 6D). There are two codes for this command. Both codes
perform the same function.
A Line Feed is executed first if print buffer is not empty.
Example:
MSComm1.Output = Chr$(&H19) or
MSComm1.Output = Chr$(&H1B) & Chr$(&H69)
Perform Partial Knife Cut
ASCII
:
SUB
or
ESC m
Hexadecimal
:
1A
or
1B 6D
Decimal:
26
or
27 109
Cuts the receipt, leaving 5 mm (.20 inch) of paper. This command is implemented the
same as Full Knife Cut (19, 1B 6D) which results in a partial knife cut. There are two codes
for this command and both perform the same function.
Example:
MSComm1.Output = Chr$(&H1A) or
MSComm1.Output = Chr$(&H1B) & Chr$(&H6D)
Exceptions:
Line Feed is executed first if the buffer is not empty.
Summary of Contents for 7197 II SERIES
