7197 Series II Owner’s Guide
Chapter 6: Commands
August
2011
187
FS – Turn underline mode ON/OFF for Kanji
ASCII
: FS
-
n
Hexadecimal
: 1C
2D
n
Decimal:
28 45
n
Value of
n
:
0 = Cancel
1 = 1 dot height underline
2 = 2 dot height underline
Default
n
:
0 (Cancel)
Turn underline mode on or off for Asian character.
All characters could be underlined, including character right side spacing.
Underline can be selected by FS ! and ESC – also, the last received command is effective.
Example:
MSComm1.Output = Chr$(&H1C) & Chr$(&H2D) & Chr$(n)
Define user-defined Kanji characters
ASCII
: FS
2
c1 c2 d1 … dn
Hexadecimal
: 1C
32
c1 c2 d1 … dn
Decimal:
28 50
c1 c2 d1 … dn
Value of
c1
:
Specified the beginning Asian character code
Value of
c2
:
Specified the end Asian character code
Value of
d
:
Image data
Summary of Contents for 7197 II SERIES
